BOBCAT Error Code Logo

Bobcat E20 32-23 Error Code

32-23 Fault Code Meaning :

Acs Controller Not Calibrated

32-23 Error Code

Acs Controller Not Calibrated is the main cause of 32-23 error.To solve 32-23 locate and open the low-pressure valve, then attach the refrigerant to the valve and charge from there. Ensure you use the right refrigerant type and amount, as specified by a manufacturer. It is possible to overcharge the AC, so consider seeking help from a mechanic.

Bobcat E20 Photo

Tip For E20 Model

When an engine is running in an enclosed area, fresh air must be added to avoid concentration of exhaust fumes. If the engine is stationary, vent the exhaust outside. Exhaust fumes contain odorless, invisible gases which can kill without warning.

Do not engage the starter for longer than 15 seconds at a time. Longer use can damage the starter by overheating. Allow starter to cool for one minute before using starter again.

About | Contact | Privacy

Copyright © 2019 All rights reserved.

Bobcat Error Code

This website is not official or registered website. Please go official Bobcat website.

Sitemaps : 1-2-3-4-5